Cut 1/4" off one side of the 1" square of black glass leaving a
3/4"x1" rectangle.
Place shelf paper on base of MicroKiln.
Place black glass square on shelf paper.
Arrange dichroic glass pieces in desired pattern
Carefully place base of MicroKiln in microwave without disturbing
glass arrangement.
Place MicroKiln lid securely on base.
Microwave on high for approximately 4:30 minutes depending on
microwave wattage. Time is based on my 950 watt microwave.
Your time will probably be different.
(See important note below*.)
If you want a sharper, more defined effect, microwave for
15 seconds less.
When microwave stops, put on your gloves and carefully move
MicroKiln
to heat-proof firebrick base or ceramic fiber mat -- at least 12"
away from any flammable articles or surfaces.
Allow your piece to cool (anneal) at least 20 minutes
to prevent breakage.
Remove MicroKiln lid and place upside down on heat
resistant surface.
Allow piece to cool until comfortable to
handle.
Wash, rinse and dry your piece.
Important Note:
Firing time varies depending on microwave wattage and size and
thickness of your design.
It will take some experimentation to determine how long you should
fire your
design after you see the orange glow. Carefully note the time when the orange glow
(indicating glass
fusing temperature) appears and write it down. You will need
this information for reference when
you create new designs.
Think Safety while working with
your MicroKiln!
We are not responsible for any damage or injury
from following these instructions. Use at your own risk!
Home
