Cut a thick glass square into 5 long pointed sections.
(You will use 4 pieces in this design.)
Place shelf paper on base of MicroKiln.
On shelf paper, arrange two long vertical pieces of glass parallel
to each other a short distance apart,
one slightly higher than the other.
Lay two pieces of glass across the vertical pieces making sure the
overlapping pieces are stable.
Rearrange until the angles create an attractive pattern.
Place one small piece of dichroic glass where desired on one of the
bottom vertical glass pieces.
Carefully place base of MicroKiln in microwave without disturbing
glass arrangement.
Place MicroKiln lid securely on base.
Microwave on high for approximately 5:00 minutes depending on
microwave wattage. Time is based on my 950 watt microwave.
Your time will probably be different. (See important note below*.)
When microwave stops, put on your gloves and carefully move
MicroKiln
to heat-proof firebrick base or ceramic fiber mat -- at least 12"
away from any flammable articles or surfaces.
Due to its thickness, allow your piece to cool (anneal) at least 30 minutes
to prevent future breakage.
Remove MicroKiln lid and place upside down on heat
resistant surface.
If piece is still very hot, allow to cool until comfortable to
handle.
Wash, rinse and dry your piece.
Important Note:
Firing time varies depending on microwave wattage and size and
thickness of your design.
It will take some experimentation to determine how long you should
fire your
design after you see the orange glow. Carefully note the time when the orange glow
(indicating glass
fusing temperature) appears and write it down. You will need
this information for reference when
you create new designs.
Think Safety while working with
your MicroKiln!
We are not responsible for any damage or injury
from following these instructions. Use at your own risk!
Home
