Cut 1" square thin black glass into 5
strips, then lay 3 black strips on top of
clear base using photo above as guideline.
Cut two strips thin clear dichroic glass to
fit spaces between black strips.
Place clear glass cap on top of second
layer.
Carefully place base of MicroKiln in microwave without disturbing
glass arrangement.
Place MicroKiln lid securely on base.
Note: Clear glass bases take longer to
microwave than black bases.
Microwave on high for approximately 6:00 minutes depending on
microwave wattage. Time is based on my 950 watt microwave.
Your time will probably be different.
(See important note below*.)
When microwave stops, put on your gloves and carefully move
MicroKiln
to heat-proof firebrick base or ceramic fiber mat -- at least 12"
away from any flammable articles or surfaces.
Allow piece to cool at least 30 minutes
to prevent breakage.
Remove MicroKiln lid and place upside down
on heat
resistant surface.
If pieces are still very hot, allow to cool until comfortable to
handle.
Wash, rinse and dry your pieces.
Important Note:
Firing time varies depending on microwave wattage and size and
thickness of your design.
It will take some experimentation to determine how long you should
fire your
design after you see the orange glow. Carefully note the time when the orange glow
(indicating glass
fusing temperature) appears and write it down. You will need
this information for reference when
you create new designs.
Think Safety while working with
your MicroKiln!
We are not responsible for any damage or injury
while following these instructions. Use at your own risk!
Home
